Setting up the Network in the HyperScale X Nodes

Updated

Setting up the network is the first phase in deploying the HyperScale X nodes. All the network related information is required during this phase.

Note

Make sure to determine your network topology before setting up the network in your Commvault HyperScale X nodes.

Cisco Fabric Extenders (FEX for short) are not conducive to storage based solutions, and therefore it is not recommended to connect any HSX nodes to a Cisco FEX. If they are connected to a FEX, stability and performance issues can arise.

Network can be setup using one of the following configuration methods depending on the network topology for your environment:

Was this page helpful?

Your Opinion Matters!

How likely are you to recommend Commvault's documentation site?

0 = Not likely at all 10 = Extremely likely