Visible when Network Route Configuration is set to Basic. Use this tab to select the type of network route configuration between the selected CommCell component and the CommServe.
This Computer is
Specifies whether this computer is in the same network as the CommServe.
-
Always in the same network as CommServe
Click to specify that this computer connects directly to the CommServe (no firewall between them). CommCell services of this computer and the CommServe can directly communicate.
-
Always outside of CommServe network
Click to specify that this computer will always connect to the CommServe from a remote site. This option allows you to configure direct tunnel connections and proxy connections.
-
May travel outside of CommServe network
Click to specify that this computer will occasionally connect to the CommServe from a remote site. This option is recommended for laptops and other mobile devices that routinely move in and out of the network.
Note
When connecting to the CommServe, this option will first attempt to establish a direct connection (same CommServe network scenario). If it fails, the direct tunnel connection or proxy will be used.
When connecting from outside
Available when This Computer is is set to Always outside of CommServe network or May travel outside of CommServe network. Sets the type of network route configuration that this computer will use to connect to the CommServe.
-
Open tunnel directly to CommServe
Click to enable this computer to connect to the CommServe through a direct tunnel connection. By default, the CommServe will use port 8403 to receive connections from the computer.
-
Use remote proxy
Click to enable this computer to connect to the CommServe using a proxy.