Unattended Installation Using a Custom Package on UNIX Client

Updated

You can configure a direct connection from the client to the CommServe computer during an unattended installation using a custom package on a UNIX client.

Procedure

From the command prompt on the UNIX client, run the following command:

./silent_install -fwtype 0 -csclientname <CS clientname> -cshost <CS hostname> -tunnelport <tunnelport> -authcode <authcode>

Where:

  • fwtype 0 means that this client can open a tunnel to the CommServe client (required)

  • <CS clientname> is the CommServe client name (optional)

  • <CS hostname> is the CommServe hostname (optional)

  • <tunnelport> is the tunnel port of the CommServe client (optional)

  • <authcode> is the authcode of the CommCell or company (optional)

Note

If you run the command without optional parameters, the installation procedure will use recorded information from the custom package.

Was this page helpful?